chichitsai · #1 (**permalink**) 12th November 2008, 03:46 AM

Does anyone know what is the correct procedure to reset a sw44 switch? or check if it is broken. I just lost signal/quality all suddenly.

rob1971 · #2 (**permalink**) 12th November 2008, 05:04 AM

I would have to say the fastest and easiest is to unplug everything and wait a few minutes and plug in and turn ebverything back on.

Helpmelearn · #3 (**permalink**) 12th November 2008, 05:10 AM

Yes what Rob said...reboot, if still nothing..wire direct and eliminate switch, if working then switch is faulty..not working, put switch back cause you have other issues.....good luck

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode