im new to Sonicview 360P - Page 3 - Free To Air TV Forum, FTA Keys and Downloads, Dish Network, Nagravision 3

camvic · #21 (**permalink**) 2nd November 2009, 05:16 PM

take the diseqc switch out, check the pic, sat you select top left corner must match what box finds, top right corner, that's a lock
you need Q to get a lock, S is LNB to box, Q is sat to LNB, reaim, check coax connections, first you need Q, then LOCK, then scan
no LOCK, scan is useless

vice' · #22 (**permalink**) 2nd November 2009, 05:18 PM

well if ur not getting any quality and ur getting signal take off the switch run it straight from the dish to the reciever and if you don,t get any quality and ur settings are correct then it must be ur connections/LNB/Alignment.

chowsingchi99 · #23 (**permalink**) 2nd November 2009, 06:03 PM

WOHoOOO! finally it worked. lol the stupid antenna cable is loose >< thx for every1's help and patience especially camvic. ^^

camvic · #24 (**permalink**) 2nd November 2009, 06:12 PM

u'r welcome

tomgofast · #25 (**permalink**) 2nd November 2009, 11:53 PM

Try reloading 1.4 with wiznet again.I had the same problem and reloaded it and it started working fine after I loaded it and put my IP settings back in.

chowsingchi99 · #26 (**permalink**) 3rd November 2009, 12:59 AM

How come all the signals n Q are gone after few mins? I have to keep re-insert the antenna cable for them to work then everything is back to square 1.