anyone have any ideas why i can get only one channel? VS (versus)? unless there is a problem with server i should be able to get a lot more than that. but if the prob is the server i shouldn't even get that one; right?

Tired of waiting days for fixes? Click here to get 3000 channels.. NO DOWNTIME, Guaranteed!

With more information we would know how to help you faster, just how did you configure the iHub?

i have done the config so many times i can give it from memory
sv 360 premier
dhcp
local ip (my IP)
local port 1920
subnet 255.255.255.0
gateway (my ip)
dns yes
domain www.svftaiks.com
dns ip (my ip)server port 1920
serial #xxxxxxxxxxxxxxxx
priorty both

= Clock on OK

First click on your Local Area Connection in your task bar and then open the Support tab. Write down your IP Address and Gateway.

Go to channel 200, should see something. If not then disconnect the iHub from the Sonicview and remove your network cable.
Power off the unit
Wait 5 to 10 seconds
Power on the unit
Make sure you have a picture on channel 100
Attach the bnetwork cable to your iHub and attach the iHub to your unit.
Wait for the iHub screen to show on your screen then go to 200

This should allow the IP change to be updated....hope this helps....

If you are still having problems with the ihub.. Remember the server and ihub use is not so great right now..

Always power (toggle) OFF the receiver when plugging in the ihub or removing it..

What you can do is...

Toggle off the receiver
Remove or un-plug the Ethernet Cable
Toggle ON the receiver.... You will see NO ipconfig in Menu...

Now:
Toggle OFF the receiver
Plug in the ihub again
Toggle ON the receiver

(all this kind of re-sets)

Anyway now go into..Menu..ipconfig...

Settings:
Type Setting: DHCP
Local IP: This will pop in automativally
Local Port: 1920 (some users use 80 and it works)
Subnet: usually 255.255.255.0
Gateway: This pops in automatically
Use DNS: Yes
Domain Name: Pops in
Dns-IP: Believe this pops in automatically also
Server Port: 1920
Ser# (Verify it is correct)

Apply-- Be sure to apply settings

Next: Suggestion is to toggle OFF then ON the receiver again.

Note: With the latest ihub release after re-booting it seems to show "ihub connected" or some such statement.

have done as you instructed per below and still nothing. now i don't even get the VS channel channel 100 still good but that's all.

Tired of waiting days for fixes? Click here to get 3000 channels.. NO DOWNTIME, Guaranteed!