Can't get a good on boot after flashing with the serial cable. Tried many different flashes but can't get anything to work?
Tried u48 file and latest bin but everything tried still gives the same result, Open loader, select bin, hit ok, switch box on, loader starts then finishes and the box reboots but NO display just a RED light, hit ok and nothing works. Hooked to tv and a brief display says fail security? then the menu screen with install highlighted but it's frozen???
Read many many many posts but nothing worked so far, do know about pansat 2700 and nfusion hd, but am new to nfusion Solaris.
Any help/advice would be appreciated.
Thanks in advance.

Tired of waiting days for fixes? Click here to get 3000 channels.. NO DOWNTIME, Guaranteed!

Try the factory file with the cable. Then use the web loader to load stuff after you loaded the factory file with a cable. web loader is threw your adderess bar in your computer. Find the IP of the solaris then in your adderess bar type the IP a box will appear. admin and 0000. Then your in the webloader with your computer. It is so easy once you tryed it and way faster

How do U get web loader and the address bar where is it, or do U do something in the address bar of your internet browser?
Please help this dummy
Thanks

Use Web loader. I had the same problem, and loaded receiver with the Web Loader.
You must know the IP address of the receiver. There are PFD files that will explain it.

i cant find the webloader file anywhere

Its not a file that you're looking for....

do a factory reset on your solaris box, once that reboots after the factory install, then go to Menu->Internet->Network info
@ that point, set up your network as you have it setup. should have
IP address, Subnet, gateway & pvr function address.... the pvr one doesn't really matter unless you will be using it, for the time being disregard it.

Once you have that complete, return to your pc, download the new 153.1 file from the file section and save it to your desktop
Open up your internet explorer/chrome, whatever you use to surf and go to the address bar and type type the address your solaris box currently has as the IP address.. so i'd be something like: http://192.168.1.105 or something depending on your network.... user:admin/ pass: 0000

then all you have to do is select your new bin file from the webpage that comes up for the "webloader"...

Sprucy

Did you allow your Solaris to completely boot up when you flashed it? Let the receiver get the flash and then let it run through once the receiver is all at 0000 power it off and disconnect. Also if you’re new to the free to air community just a heads up any time your plugging in the coax from the satellite make sure power is off and same things when you disconnect the diseqc’s are not good for power surging. I’m an installer my self and I have run after a lot of people who did not know that mind you I’m not complaining I make an extra 20$ for just changing a diseqc cause of their mistake’s LOL.

yeah your best bet is a fact default and use the webloader, please read on it and like mentioned before "easy". hope it helps.

Tired of waiting days for fixes? Click here to get 3000 channels.. NO DOWNTIME, Guaranteed!