Dont do 8282 - Free To Air TV Forum, FTA Keys and Downloads, Dish Network, Nagravision 3

dnkeys · #1 (**permalink**) 14th May 2009, 10:08 PM

Code:

After your done loading this bin to your receiver and hook it up to TV...
Push 8282 on your remote to get to " CAS SYSTEM ".

In there you will see " SET DEFAULT KEY"... Go to " SET DEFAULT KEY "...
Push OK on remote once then EXIT out and picture should come in right away.

If you don't do that then you will get " SOBC " Nag until Keys update.
Do the " SET DEFAULT KEY " and picture should come in right away if the current keys don't change before you put this bin on your receiver.

stevega said this but plzz dont do 8282 bcz if u do 8282 and set default keys it will change the keys and u have enter them manually so dont do SDK

truetiger30 · #2 (**permalink**) 14th May 2009, 10:27 PM

If you SDK will it not autoroll to get the K.

dnkeys · #3 (**permalink**) 14th May 2009, 10:30 PM

no, because when u load the file it just comes up but if u do SDK they it changes the keys and u gotta wait like i am right now

TheRiddler · #4 (**permalink**) 15th May 2009, 01:33 AM

Quote:

Originally Posted by dnkeys

no, because when u load the file it just comes up but if u do SDK they it changes the keys and u gotta wait like i am right now

if you set default keys,yes you are correct then the current keys in file change,you will have to wait for them to roll in.....they do roll in but takes a good 15mins on 1 channel this time before they come in,but they do roll to right ones if you wait.

dnkeys · #5 (**permalink**) 15th May 2009, 01:39 AM

i loaded the pnsat 2700a file with that tronics loader and it say SOBC i even loaded the 214 lmza still i didnt get anything i waited more then 15 mins

truetiger30 · #6 (**permalink**) 15th May 2009, 03:05 AM

Try system reset or Factory Default and setup your birds and scan channels again..

Shinano-1 · #7 (**permalink**) 15th May 2009, 04:22 AM

If I understand right dn keys loading pansat 2700a file to a fortec?
I think that is the wrong thing to do.
I load the file for my fortec hook it up as soon as Receiver on
Picture came with in seconds. I never shut off the receiver, that way it is updateing keys all the time even though it is freezing.No problem with
jvvh file always works good.
Thanks to Jvvh.

nhva · #8 (**permalink**) 15th May 2009, 05:13 AM

I did SDK and was getting "scrambled" nag for 1+ hours and then I went to work at 5 - came home now at 12am and now they're working fine =D

stevega · #9 (**permalink**) 15th May 2009, 06:06 PM

dnkeys

You don;'t know what you talking about
First you can't use Tronics bin/mod/loader on a box with lzma_bin in box
And I didn't say anything, If you read what Fwank7 said set key default so you can get the a/r to start the a/r to start working take about 5 to 7 minutes to update keys, I am up and running

Post Closed

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode