Setting an Elliptical Dish
Set your dish on 90 deg (straight up) > place 110 lnb in the slot that fits in the arm of dish > looking from the back of the dish > place 119 to the left of 110 > leave slot 101 empty > place 91 lnb on the far right....

Connect cable to 110 > locate 110 > adjust elevation to fine tune > lock your dish in place > disconnect cable from 110 & hook up 119 > skew your dish until you get 119 > fine tune if necessary > if 110-119 are properly set, 91 should be there, you may have to move the 91 lnb in the slot to fine tune.
Once you have all 3 sats working, connect your switch & check everything again.
Note:
I use a tripod to set all my dishes, even a plumb pole in the ground is better than on a rooftop. Once I have it set on the ground, I move it to my pole, then its just a matter of swinging the dish side to side until I locate 110....
Bojac.......

__________________

Tired of waiting days for fixes? Click here to get 3000 channels.. NO DOWNTIME, Guaranteed!

Good info Bojac

__________________


Testing atmega 128, pansat
2700a,coolsat 4000 pro, captive works 600
prem. Maggie, Xfactor X-1

R.I.P Bojac - The Fta community will Always Remember You - Deceased December 30, 2008

Tired of waiting days for fixes? Click here to get 3000 channels.. NO DOWNTIME, Guaranteed!