How to install new serial number bin on cw 650 700 and 800 - Free To Air TV Forum, FTA Keys and Downloads, Dish Network, Nagravision 3

GrnMachine · #1 (**permalink**) 9th February 2009, 06:49 PM

How to install new serial number bin on cw 650 700 and 800

you must save channel list to save setting this is the easyest way

1 have usb mem stick in reciever
2 press usb button on remote
3 now u will have usb menu
4 press fav button on remote
6 now it will ask u to save data right click volume and it change the no to yes and click ok on remote
now u have save you channel list and setup data

ok now for new files

1 load new file to usb
2 now put usb back in reciever
3 press usb button on remote file the new file
4 highlight new file press ok it will ask you do you want to update right click volume button one time now it will say yes
5 press ok data will start to load to reciever you will be able to tell by the front of the reciever the numbers will be counting down now wait for it to say end
6 now it will ask you do you want to reboot right click volume up 1 time and now it will say yes press ok
now reciever will reboot
7 now it will ask for s/n number
8 Look under your receiver and you should find a sticker with your personal serial number
9 You do not enter letters only the numbers and should be 9 or 10 digits long
10 and then after u finsh with entering s/n press ok
11 now it will ask again for it put it in and press ok again
now reciever will reboot 2 times

12 ok that done do a factor default

ok bin is loaded now u can do your setting manualy or you can load the channel list and setting

to load the channel list and setting is verry easy u just

press usb button with usb momery stick in reciever
u will see a sdx file it will look like this
Captive Works_CXDatabaseV1.00_1.sdx
highlight it and press ok
now it will ask you if you want to upload the data right click volume up 1 time now it will say yes press ok
and number will start counting up when it done it will say end on reciever then just turn off from back power switch and back on
you should be all set at this time

cp

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode