Iks Ok channels all down on both units

Tired of waiting days for fixes? Click here to get 3000 channels.. NO DOWNTIME, Guaranteed!

there runing on iks mines working fine do a reset and load the 118 bin again and see what happens

I did factory reset loaded 805 and 118 scanned 119 no results on one unit only signal and epg loads ok.

I had same trouble I did factory reset then put the old file on works good now not sure why the new file worked for me for about a week then it just quit no matter what i did i could not get new file to work

It will not let me load an old file.

I did further testing the final abservations are: New Factory 8.05 reloaded, 1.18 reloaded, scanned 119, 110, Iks link is Ok. The final result I get blank screen "Scramble" on both Nano2. I have no idea what else I can do to bring these units back working. Previously I had problems with both receivers freesing totally and had to tun on and off with the rear switch to get TV back. Your feedback is badly needed.

the only thing that worked for me was loading the 1.17 file to me a few times but it took and worked sorry that's the only thing I can tell you have not hat the box that long

you are right taurus99 I just loaded 1.17 both units wonking good. Thanks for the help

I still cannot watch TV after I loaded 1.17 the freezing is horrendus to the point that is not usable. Now I am declaring CNX is down hopefully the coders will resolve this problem.

Problem is on your end, Nano2 is up.....Start from scratch, load 8.05 as boot,then 1.18 as s/w, then re-set your settings, scan your sats, turn IP to auto, and you should be good to go.....

__________________
a.k.a. HeavyChevy

Sharper than an old jackknife, poison, like a rusty nail.....

If you have 2 units,make sure that they both don't have same IP.

__________________
It works 60 percent of the time every time

Tired of waiting days for fixes? Click here to get 3000 channels.. NO DOWNTIME, Guaranteed!