how can i tell if i am hooked up to the server? i am on channel 304 the hbo2w and am getting a good signal but still says no service or scrambled. why won't this setup work? someone must have the answer. lol
have read and printed out all the ihub manuals and trouble shooting files but still cannot get the ihub to work.. have a sv8000 using belkin powerline adaptors to the ihub. settings in the config are as follows
Here is some help....
user
setting type dhcp
local ip 192.168.2.3
( Double click on the internet icons in your task bar and under the support tab write down the IP address and gateway. Enter your IP address and only change the last three or two numbers to anything)
local port 1920
( Change to 80 )
user dns yes
( Mine does not have this )
subnet 255.255.255.0
gateway 192.168.2.1
( Type your gateway address here )
use dns yes
( NO )
Server IP
( 77.93.75.89 )
domain name
www.svftaiks.com (This will go away )
dns ip 192.168.2.1
( Enter your gatway )
server port 1920
seral number is the ihub number.
At the bottom click on apply
have double checked # with
Go to channel 200, if not then power off diconnect iHub, wait a minute turn your unit on and insert the iHub..if your getting 100 then something is right...get back
magnifying glass to be sure it is correct.
used priorty both
all i get is no service or scrambled. just have sat echostar7 in system. hdthr is working but no n3.
equipment is as follows
wildblue satilite modem hooked to belkin router
router connected to desktop computer using vista and to belkin powerline adaptor
belkin powerline adaptor connected to 120v house wire outlet
other belkin powerline adaptor connected to 120v outlet and to ihub using rj45 ethernet cable
ihub connected to sv8000
green and amber lights on at the ihub
no n3 channels
any and all help would be greatly appreciated. thanks in advance