When you setup the ihub did you install the ihub over the program you had in there? Have heard of some problems.
I know for a friend he followed these steps:
Quote:
Dis-Connect the ihub
Write down your satellite (Lnb Type, DisEQc switch, etc) settings
Factory Default
Load the SystemCleaner --For your receiver
Load the latest Factory File
Load the.. ihub file... (only ihub file)
Put in your settings again, scan satellites, set-time, etc
Now... Again connect the ihub and follow the set-up guide
Look for the two ihub LED lights to be on (located near to where you plug in the Ethernet Cable).
|
During the setup the Local Ip and other IP information plus the Domain Name filled in automatically.
In looking at your local ip:
It has less numbers that I have seen before. xxx.xxx.x.xxx
But then again it very well could be correct for you.
Another issue might be the router you are using. I know you are using the belkin powerline adaptors to the ihub. Believe you go from the router to the powerline adapers.
But...You do have the LED lights..
There are just so many different routers and other items being used. I would say try the set-up again... See how that works.. Let us know the Router you are using plus the company providing your high speed internet. I'll search sites I visit if the set-up again does not work and see if I can find out anything..tomorrow...