stevega said You will have to jtag the skytech, Don't know how it went dead unless you used BL_2700 bin, use only clone_2700 bins !

1-- jtag cable needed
2-- remove cover of sat box only 3 screws.
3-- make sure your sat box is off and your computer is not running any programs.
4-- connect your jtag cable to computer and to reciever.
5-- now turn on sat box on rear switch
6-- open skymax 2.2 can be dowloaded basically any site make sure its a recommended site.>>> LIKE Free Satellite TV Forum, Free to Air Satellite, Satellite Key, Dishnetwork Key, FTA Receiver, Viewsat, Coolsat, Pansat, fta satellite, fta file, satellite tv dish network, Fortec Files, Viewsat Files, Viewsat Keys, Coolsat Files, Coolsat Keys, Dishne
7-- change setting under adr flash to setting 2mb (7FE00000) and make sure select LPT port 1.
8-- under connection click start and wait till complete then under flash operation select erase and wait till complete.
9-- now under flash operation you will select write a window will pop up at the bottom change from rom file to all files. then select the pansat 3500s-flash 1(29LV160CBTC-70)-full.once you selected this file skymax will automatically start the process of writing the file to your sat box.depeding on your computer it may take a while.
10-- once it says complete turn off sat box remove jtag cable.
11-- once jtag cable is removed turn on switch and
the display screen should show b70,if so you have completed this procedure correctly.
12-- now you just have to load the boot file 80 and the current bin.
13-- enjoy.





c/p info

__________________