|
Have two working Xtreme's so have a bit of knowledge with Xtreme's. Since the Bev is the problem let's work thru Bev only and you can add in the others after Bev.
As brat6990 mentioned we have to make sure your dish is locked onto Nimiq1
Try this:
1. Factory Default
2. Connect only the Bev dish to the Xtreme
3. Go into Installation then Antenna setup
4. Select Nimiq1 for the satellite (make sure of these settings) Lnb 11250 , tp 12224, DisEQc none
5. At this point if you are locked onto Bev (on the top of the screen) directly across from "Antenna Setup" you should see the words Nimiq 1. This indicates you are locked onto Nimiq1. If you are not locked onto Bev@91 degrees you will not see Nimiq1.
6. If this is correct I would then exit which puts you into the screen where you can scan so I would just scan that one satellite. (Not Blind Scan)
7. Exit, Exit an so on all the way out. Hopefully you will have Bev now.
8. If auto-rolling I would first go to a non-scrambled channel to verify there is a picture. If yes then go to 220 (A-London) and let it roll
My thought is that you are choosing Nimiq 1 (91 degree) and the scan is scanning for those transponders/frequencies on that satfile. Then when you do another blind scan you are scanning everything so if you are not locked onto Bev you are scanning all transponders and frequencies from whatever you are pointed at with that dish.
My belief is that your dish might be on Nimiq 2 vice Nimiq 1. Wish I was there to help.
|